Clear Coat Fix: Dust Nibs, Runs & Light Scratches
The job: dust nibs, small runs, orange peel or light scratches in cured clear coat. Here's the exact setup we recommend, in order, so you get it flat and glossy in one pass with no guesswork.
What you'll need
- Indasa Dry Guide Coat: shows you the low spots and defects
- Indasa 3" Rhynofinish Foam Finishing Discs or Wet/Dry Sheets P1500 to P3000: to level
- Indasa Rhyno Sponge Hand Pads: for edges and curves
- Indasa Autogloss Compound Plus or Mirka Polarshine 35: to remove sanding marks
- Indasa Autogloss High-Gloss Plus or Mirka Polarshine 10: final gloss
Step by step
- Make sure the clear is fully cured. Wash and dry the panel.
- Apply guide coat over the defect.
- Level with P1500, then P2000, then P3000, only until the guide coat and defect are gone. Keep an eye on edges and body lines so you don't sand through.
- Compound to remove the P3000 marks.
- Finish with the polish for full gloss, then wipe and inspect in good light.
Not sure what you need?
Tell us the job and we'll put the right setup together for you. Call 631-991-7188 or email info@unitedfinish.com. Orders placed before 2 PM ship the same day.
